LFI SANITIZER

EPA approved sanitizer
Organic soil tolerance
Effectiveness over a wide range of bacterial, viral, and other micro-organic contaminants

Dilution rates:
1 ounce of LFI Sanitizer to 5 gallons water = 25 ppm
2 ounces of LFI Sanitizer to 5 gallons water = 50 ppm

Equipment Sanitizing:
Pre-clean: wash with cold or lukewarm water with a 25 ppm active
Sanitize: 25 ppm clean solution with 1 minute contact time, then drain sanitizing solution.

Tank and Vat Sanitizing:
Pre-clean: wash with cold or lukewarm water with a 25 ppm active
Sanitize: 25 ppm spray, or fill vat and allow 5 minute contact time prior to draining off solution

Sanitizing of walls, floors, conveyors, and food contact solution.
Pre-clean surfaces by scraping or flushing to remove soil. Then clean with 50 ppm solution, then rinse with potable water. Sanitize with 25 ppm and allow 2 minutes of contact time (do not rinse, allow to dry)

Beverage Containers:
Sanitize previously cleaned containers that were first washed with detergent and rinsed use a solution of 25 ppm with 1 minute of contact time. Invert containers, drain, and allow to air dry (do not rinse).

High foaming of iodophor sanitizers
Limited tolerance to soils and organic contaminants
Low effectiveness against a particular type of microbes