A rehabilitation process is required as part of the water-well maintenance routine to restore the water quality and pressure. Low-toxicity and high-biodegradability acids are used to rehabilitate wells and clean scale, deposits, and biofouling off the well pumps.
Glycolic acid (hydroxyacetic acid) is one of the top solutions for well rehabilitation, flow stimulation, downhole drilling, and new well-cleaning applications. It is an organic acid that provides superior cleaning efficacy for hard water scales, including calcium carbonates, magnesium carbonates, manganese, and other mineral salts. It also cleans various iron deposits, polysaccharide deposits, and biofouling or biological film formations. In addition, Glycolic acid is widely used as a descaler for inorganic and organic impurities in various industrial applications, including water treatment, and oil and gas.
Why Glycolic Acid For Water Well Rehabilitation
- Glycolic acid from PureTech Scientific, previously manufactured by Chemours, is NSF certified for the cleaning of potable water wells
- It chelates iron and metal salts by forming water-soluble compounds that are easily rinsed away
- Glycolic acid is less corrosive and safer to use in contact with the well metal compared to mineral acids such as hydrochloric
- Its low molecular weight and small molecule size enable fast penetration into difficult deposits
- Glycolic acid from PureTech Scientific is chloride-free for lower corrosion rates on sensitive metals
- Glycolic is biodegradable and non-flammable, and it has low odor, low toxicity, and negligible fumes
- It has higher efficacy in removing hydrocarbons and tough scales compared to citric and formic acids
- It has excellent compatibility when blended with other acids to improve cost efficiency and cleaning effectiveness
- The carboxylic acid provides excellent removal of polysaccharides and common organic deposits
How To Use Glycolic Acid for Water Well Rehabilitation
The Pretreatment Steps of Well Stimulation
- Measure the water flow and compare it with historical flows to determine the flow deterioration over time, and set a goal for when the cleaning procedure is required. The flow typically deteriorates because of gradual damage to the well formation, accumulation of carbonate deposits, or mechanical damage to the downhole filter system.
- If iron bacteria is present, the well will need a chlorination shock treatment by the injection of chlorine solution to loosen the slime and organic biofilm deposits.
- Apply a high-frequency shock to loosen the scale by detonating blasting caps in the water wellbore.
- Purge the well and check for large amounts of rock and gravel that can indicate a problem with the screen or the gravel pack. If a mechanical issue is present, it needs to be fixed before the cleaning procedure.
- Measure the water pH to determine the required amount of Glycolic acid for the cleaning procedure.
The Application Steps of Well Rehabilitation
- Determine the Required Amount of Glycolic Acid
Add Glycolic acid 70% solution at a rate of 1/2 gallon/ ft³ standing in the wellbore. This should give about a 5% concentration of the acid in the water. The acid can also be pre-mixed with water in a preparation tank if needed.
Example: A well with a diameter of 10" and 126 ft deep with a static water level of 30 ft below the surface would require (126 – 30 ft) x 0.241 = 23.1 gallons of Glycolic acid 70% solution.